Re: Looking for an affordable tubing bender.

Posted by shinyribs on Apr 20, 2012; 10:57pm
URL: http://vintage-and-classic-hondas.81.s1.nabble.com/Looking-for-an-affordable-tubing-bender-tp3922097p3927255.html

Cabreco wrote

Have you checked out the HF units?

http://www.harborfreight.com/catalogsearch/result?q=bender

Thanks Cabreco.That is the one I have now.It does an ok job.The thicker the wall,the better it acts.Those will do bends up to about a 45 degree pretty good,but a full 90 I just cant make it act right

Luke-I tried the sand trick.It did seem to help,but i was using aluminum tubing I didn't mind wasting and it just popped it open under the pressure...but up til then it was looking good!