Re: 77 cb750f2 Master cylinder questions and great deal on braided lines.

Posted by Matt Story on Sep 02, 2012; 2:58pm
URL: http://vintage-and-classic-hondas.81.s1.nabble.com/77-cb750f2-Master-cylinder-questions-and-great-deal-on-braided-lines-tp4028392p4028504.html

Yesterday morning I went down to the local repair shop and asked my questions.  The owner/mechanic looked up my assemblies on his micro-fiche and to;d me that I didn't ,need the check valves on my machine.

Also talked to him about the relief hole in the master cylinder.  Didn't learn much there.  I solved this one by some trial and error.  First I got a small piece of copper wire strand to go thru the hole.  I then chased the hole with a 1/64" drill bit and pinvise.  I didn't see any aluminum shavings, and the hole is clean thru now.  I searched high and low for a dimensional spec for this small hole, and didn't find anything.  I am going to go out on a limb here and state 1/64".  If anything, I think that is a hair smaller than the actual hole so it should be safe.

Matt