Re: Cleaned my carbs, bike won't run right. Pls help

Posted by seestheday on Jan 21, 2013; 2:11am
URL: http://vintage-and-classic-hondas.81.s1.nabble.com/Cleaned-my-carbs-bike-won-t-run-right-Pls-help-tp4035484p4035519.html

Wait, all the jets? Did you mix primary and secondary?   Do they look the same on these carbs? On the dohc carbs it is possible to put primary jets where secondary jets go and vice versa.  If you mix them up the sizes are wildly different, and your bike won't run right. 

Sent from my BlackBerry device

From: Muscle racer [via Honda CB750'S] Sent: Sunday, January 20, 2013 6:54 PM To: seestheday Subject: Re: Cleaned my carbs, bike won't run right. Pls help

Yea the nail was big. Then I tried a very thin copper wire I stripped from another wire. It worked.

Yea, I keep hearing about a bench synch but I don't know how to do that. It was a pain getting the carbs and the airbox to get back on, but ill take them off to get it going again.

I read that it's good to keep all the jets together but seperate from the other jets. I just put everything together and cleaned it. Everything looked exactly the same, so I didn't think it mattered

---

If you reply to this email, your message will be added to the discussion below:

http://honda-cb750-s.456789.n3.nabble.com/Cleaned-my-carbs-bike-won-t-run-right-Pls-help-tp4035484p4035509.html

To unsubscribe from Cleaned my carbs, bike won't run right. Pls help, click here.
NAML