Re: New chopper, new problem

Posted by hambone on Jan 08, 2014; 12:35pm
URL: http://vintage-and-classic-hondas.81.s1.nabble.com/New-chopper-new-problem-tp4047941p4048066.html

cbchop the bike is awesome.this is what I did to get pods to work excellent.revs to redline.pulls all the way to a hundred.surpising power.took me a long time to get it right...here goes...rejet replaced main jets 120s on outer two cylinders #1 #4.used 122.5 main jets on inner two cylinders.75 on primary jets across the board.drilled slide holes (carefully) with# 14.only the existing holes!cut slide springs 1 complete loop.the needle is raised two small washers very small(forget the size I will dig it out if you like).ultra clean carbs and sync of course!now for the pods themselves...I mated all four original airbox boots to the pods.very very important.makes the bike run night and day!!!! I simply cut the flare off the ends inserted aluminum ring so I could clamp rubber to rubber...also inserted aluminum hand made disk in the pod.sort of like a half moon.ive used baffle type too.(one hole in center surrounded by smaller holes)I will try to get pictures up of this...again this is what I did.im at sea level also.alot of elbow grease but inexpensive..alot of trial and error.but well worth it. I sincerely hope this helps.