Help with this question?

Posted by itsblue on May 16, 2010; 11:39pm
URL: http://vintage-and-classic-hondas.81.s1.nabble.com/Help-with-this-question-tp822438.html

Hello,
I have a 1975 cb 750 SS and have bent one of the brass tubes the carb jet screws into.  I could not bend it straight and the needle kept hanging up in it, so I bored it out.  The question is : since the 120 jet orifice controls the intake amount and the sleeve the needle drops into controls the metering out will the boring affect that carb and be a problem?  If you guys think so does anyone have one I may buy because I have been unable to find one.  Thoughts, comments,  ideas, advice appreciated.

Thanks  Stephen