Can these be made to fit?

[EsRacingNo?]

Just seen these 32mm replica Keihin flat slide carbs on ebay and wondered if they could work with a DOHC 750 motor.

I would have to fashion up a mechanism so that the throttle cable pulls and returns the slides simultaneously in the carbs, and maybe some kind of adapter to mount the carbs to the motor (I'm unsure if my 82 CB 750 FB has the same size carbs).

Anyway, here they are.

http://w12.myzcm.com/2010/03/nancyined2009/%E6%97%A0%E6%A0%87%E9%A2%98dd.jpg

http://w12.myzcm.com/2010/03/nancyined2009/%E6%97%A0%E6%A0%87%E9%A2%98dtgdegt.jpg

http://w12.myzcm.com/2010/03/nancyined2009/dscf1406.jpg

http://w12.myzcm.com/2010/03/nancyined2009/dscf1407.jpg

[Re-run]

Ohh hard to say. It does not look like those carbs are made to attach to any brackets. I think if you could make a bracket to hold the carbs side by side, that will fit the spacing needed, you might have a change but 32mm is a large carb for a 750 unless you have engine mods so they may not work very well.