wiring harness plug

[katman]

Happy 4th everyone. Out working on my 75 project. Clean the wire harness and need to replace the plug.
Anyone know how I can get the wires out. Have a outside plug to go back on.

[Piute]

                                    Ya see how the slot has a lil slot on it (top)there

                           Thats were this lil nib thingy goes in and make hard to pull out.


   Now,from the otherside from contact(brass thingy in molding,
   You wont to push a needle to push that nib down from catching molding as you pull it "out" the wire side(oppisit needle side)this is very easy (if you get that nub pushed down) I grinded a eye glasses screw driver lil flatter and longer ,now electrical tool.1st couple lil tricky ,hope your new molding came with new contacts.good luck.
    remember to tug each wire a bit to be sure clamped real good,cause will get pulled while in use best to be sure now.