Help with this question?

[itsblue]

Hello,
I have a 1975 cb 750 SS and have bent one of the brass tubes the carb jet screws into.  I could not bend it straight and the needle kept hanging up in it, so I bored it out.  The question is : since the 120 jet orifice controls the intake amount and the sleeve the needle drops into controls the metering out will the boring affect that carb and be a problem?  If you guys think so does anyone have one I may buy because I have been unable to find one.  Thoughts, comments,  ideas, advice appreciated.

Thanks  Stephen

[Re-run]

Well boring it out will increase the size of course and prevent the needle from doings its job.
You might try bike bandit or sudco.com.
Check through the online sellers list here.

[vern401]

yes it will cause a problem.