hot wire ,also run lights, to ride,EMERGENCY

[Piute]

  Bike died a couple blocks from house,played with switches and wiggled wires under ignition,LIGHT came on started took home.

   Didn't think I was going to show how to hot wire MY bike,Can /will help with yours
   P.M. me and I will P.M. you back how it's done.

[shinyribs]

Do you have an Ohm meter? I would just pull the plug off the back pf the ignition switch. Then,while working the switch from 'OFF' to 'ON' see what two terminals make that connection.

You bike may be different,but on mine there is one fat red wire that feeds everything on the ignition switch. If you tie everything all together you should be hot wired-IF your switch is the same as mine.

The ON position applies voltage to the coils and the light circuit
The PARK position applies voltage to the tail light only.

If you tie everything together is should light up everything,including the coils.

[Piute]

RIBs""Do you have an Ohm meter? I would just pull the plug off the back pf the ignition switch. Then,while working the switch from 'OFF' to 'ON' see what two terminals make that connection.""


  The HOT inside the switch is whats bad, Has all new brass conectors in plugs, To night I cut aprox. 1inch back on male pug and addded new brass female connectors in it,(thinking maybe wires broke inside cover(plastic),RED wire got warm I noticed then ,So traced it to be bad YA-No (right ?).

  "O" I've had a ohm meter for 20 something years still new I never used it but others have on my stuff.
    Idiot (ice-pick)tester fo me .or jump to a signal bulb.

   I'm hoping my 1st idea will work ,just having to unhook batt. to turn off.(gottem switch I thunk) few days till another switch. 5 wire's can't be all that hard to find....HELP.....

[alfa750]

CONTENTS DELETED

The author has deleted this message.

[Piute]

   Thx. neede the backing been a long after work day trying to find bad.

                                           



YOU ARE PURCHASING A NEW AFTERMARKET IGNITION SWITCH THAT WILL FIT THE MODELS LISTED BELOW.THIS CONTAINS 2 NEW KEYS MATCHED TO THE SWITCH.REPLACES HONDA OEM PART NUMBER 35100-422-017 AND 35100-438-007

HONDA

1975-1977 CB

                             8 To 9 days only 35 bucks

[Piute]

     WELL,
   It worked ,after blew fuse,then melted front winker wires,(short reason for blown fuse)
  But got to and fro from work hot wireing these bikes is to dang easy ,When you knnow what your doing 5 min. easy.