Piute putt 1977 CB 750 F2

[shinyribs]

You need a set of these.Got mine for $12.99.You can hardly see them on the bike,but they are SUPER bright,even in the daylight

[Piute]

and how well can they be seen from the side while sitting in a truck during the day,Lil lights are cool but not for me,All My lights will be changed once I have my faring on.
 Longer you run on the track more likely to have problems

[shinyribs]

Hmm...good point

[Piute]

                                                Piute Putt

Besides Light are only for a fare start after that

[shinyribs]

A little street racing reference,huh?  You know what i say!...gimme tha kick!

[Piute]

                                                          Straight up


                                              OH NO are next generation

[Piute]

                                               Piute Putt Eng. Mount (frnt)
 Went to put on a crash guard and the engine mount(front down tubes) bolts Well the one with the (R) Lil plate hole was threaded into the cases but stripped like ao.k. On the (L) They threaded through the frame sold inch and half maybe then cases,but only put in a 1 inch bolt,
So all this time not even in tight just wedged, between the frame

  Drill completely through with 15/32 drill both side used grade 8 ,7/16-14 x one 3 1/2" other 2" bolt/nuts
This could of been DEADly
                                               
                                                Bolts fit ground Lock washers Lil

                                                Left side 3  1/2 "bolt

                                                 Right side 2 " bolt

[Piute]

                                          Piute Putt Micky mouse

 

[Piute]

  Waiting on some rubbers(kick,shift)also some fresh pads,
SObroke out the heatlamp and painted the triple trees and some other small stuff,planing a light bar since I found the lights I wont,Brass

 

[shinyribs]

Sounds like a plan! Man,those tires look tough

[Piute]

 Only the front fer now
previous owner put new Dumb-lop on back (wont to buy it)new still has nipples,
Naa I'll run it (may be)
 Use it in the burn-out pit

[Piute]

CHECK

[shinyribs]

Piute wrote

CHECK

Oh crap!I forgot to check that wheel for you.My bad. Im on it

[Piute]

 Was "check"ing ,A signiture thing didn't work,   

[Piute]

Well finally put the scallop on piute putt and another coat of blk.gloss
 Need to add some flat blk. and my tribal flame ,but like this as is ...........well with the flat outline (tomorrow),think the stock design with my colors is fine

[shinyribs]

I like it.I really dig your side covers you made.Is the crash bar new?

[Piute]

 TANKSHaven't got the other side right yet ,but plenty of time and don't look bad with the paint , New to me , the crash bar came from a 80 Gold wing,works great for jacking up, took a center cap(car) cut a slot in it for floor jack put a bunch of glass n resin in then peace of wax paper (wont stick) put back on jack(jacked up) and it molded itself,4x4x6couple "L" brackets covered in plastic dip.
 Also put some of that dip on top of crash bar so my feet don't keep slipping off but has hwy mount in center too.
 

                                                                                       Got the rear wheel done,
Have A early 80s cb rear 16" looks as though the inner hubs can be switched with mine ANY one try that ?

[Piute]

                                                          





  can see hub through gear  blk  cast gry orange piute putt n judose



                                 
                                        Ears flat black just like M i c k e y  

[Piute]

 
                                              After looking at my pic's
                                                            PIUTE PUTT
                       I'm going to take off a few more ribs on these Gators(think I can)


                                                  piute n judose

                       
                       Yep more paint Ute came out of hibernation to check the tape 1st

[Piute]

                                                     
                                                                PIUTE PUTT


               After rubbing out Piute putt with compound then Wax will be Quality



Clear coated the gauges and small things ,listening to all the bikes out today 60s
 putting the badge back on after buff.. PIUTE PUTT